Calibration Settings

Calibration Steps:

1. Initial Setup

• Ensure all components are securely connected per the manufacturer’s instructions.

2. Power On

• Plug in the system and power it on. Allow it to warm up for a few minutes before calibration.

3. Load Calibration

• Place the material into the agitation chamber.

4. Set Agitation Speed

• Access the control panel of the Smart Agitation System.
• Start by setting the agitation speed to a low setting.
• Gradually increase to the recommended speed for your specific material.

5. Timing Calibration

• Set the timer according to the recommended agitation time for your material.
• Monitor the agitation process closely during this time.

6. Temperature Calibration (if applicable)

• Adjust the temperature settings as needed to maintain the optimal temperature for extraction.

7. Test Run

• Once calibrated, run a test batch using the settings you’ve established.
• Observe the process and make any necessary adjustments to speed or time based on the results.

8. Record Settings

• Document the calibrated settings, including material type, speed, duration, and temperature for future reference.
• This will help maintain consistency in your extraction processes.

Routine Maintenance

• Regularly check and recalibrate the system, especially after significant use.
• Keep the system clean and free from any material buildup to ensure accurate readings.

Troubleshooting

• If you notice inconsistency in results, consider recalibrating or checking for any mechanical issues.
• Always refer to the user manual for specific troubleshooting related to your model.