Home Page - Plate Movement Calibration

Software Screenshots

Technical Explanation

Access Rosin’s® FTC or Flow Control Technology Software is the hub to The Rosin Machine’s ability to precisely control a 100-Ton double-acting hydraulic operating system.

The Rosin Machine runs FCT software to automate the steps in the pressing process such as applying PSI, regulating PPSI, and increases the PSI automatically throughout the cycle. During a press, the heat plates are temperature controlled by an intergraded PID controller within the FCT Software.

Home Page

• Plate Movement: To enable the 0 P.S.I for sensitive beginning cycle pressure, and/or used as prepress, calibrate the plate movement to the thickness of the pouch.
• • A. Plate Height “Start Press”: Use this time (seconds) setting to calibrate the top plate height, after pressing “Start Press”. A ready-to-press pouch should fit sung between the plates.
  • B. Jolt Time: Use this time (seconds) as a setting to move, after the plate height calibration, which is the first movement that moves in time to lower the plates to slightly touch the pouch, without adding any pressure. Too much time may and can add pressure. If pressure is applied past the set stage psi, then the cycle will skip those times, and cause the oil to “decarb” between the plates. Use this Jolt Motion to liquify (pre-melt) resin glands.
• Load Bag Plate Height Raise Time: If plates are too close together when inserting pouches at “load bag” screen, use this time setting to raise the plates by this set time.
• Set Jolt Time Default: This is the default jolt motion time when you use Recipe Creator. Manually input jolt time for recipes.